GRUB and BIOS woes
Because of a particular multi hard-drive configuration, I ran into a small issue when installing Fedora.
I had a mixture of classic IDE and SATA drives, and my boot disk were the SATA drives mounted as a RAID 1 array.
In fact, the installation process was smooth: I booted from the install CD and went through the installation normally but
GRUB couldn't load when I reboot: I was stuck with a blank screen with the word
GRUB in the top left corner.
What actually happened is that during install, Fedora assumed the disks were in the following order:
- HD0,0 (/dev/hda): 250GB ATA drive on IDE 0,0
- HD1,0 (/dev/sda): 80GB SATA drive on SATA Controller 0,0
- HD2,0 (/dev/sdb): 80GB SATA drive on SATA Controller 1,0
grub.conf file, reference was made to the HD(1,0) as the
Unfortunately, during the installation process Fedora did not guess the right BIOS numbering of the disks and misconfigured GRUB: while the BIOS was told to boot on the first SATA drive, Fedora gave that disk a different identification.
Resolving the issue after installation
To solve the problem, after booting from the rescue CD, I just had to edit
grub.conf and change the references
root(hd0,0) and reboot.
In rescue mode, the file system is detected but not mounted.
To edit the grub.cong file, the best is to mount the filesystem properly, then launch the editor:
Make your modifications then exit and reboot (ctrl-alt-del).
Don't forget to remove the rescue CD.
Avoiding the problem
To avoid that problem in the first place, take note of the boot order for your hard disks in your BIOS and then ensure during the Fedora installation process, at the Boot Loader Configuration page that you tick the Configure advanced boot loader options. you will then have the opportunity to change the drive order to match that of the BIOS.
BrendaFriday 21 June 2013, at 18:45 GMT+8 [X]
LeRoy HodgeTime and patience. Kids potty train when they are ready. Attempting to force or corcee them into it can result in physical and mental problems. Some children refuse to try until they are a bit older (3-4 years). When they show signs of being interested in using the potty, it is time. Encourage them by using pullups or underwear so that it is easier for them do try. If you want to go the underwear route, remember that when they have accidents, something besides the underwear (floor, bed, chair, couch) will get wet. Do not chastise them if they have accidents. Make sure everyone is on the same page so that the child is not confused.
MiwaFriday 21 June 2013, at 18:58 GMT+8 [X]
LeRoy HodgeMy son is 2 1/2 years old and we have been potty training him for a lttile bit. We went out and bought him underwear and a potty. The only way we could get him to sit on the potty is to give him a sucker. I know now he will go to the big boy potty by himself. We are trying to get him to not pee at night either. It does take a lot of time and patience. Don't give up on it though. It took my son about a week or two to get potty trained during the day.